Fig. 1 A complete EMYS robot.

Open the box that EMYS was delivered in. If you're using a sharp object to open the box, be careful not to damage the robot.
Check if the box contains the following components and confirm that they are undamaged:

  • EMYS, complete with a communication and power cable (see Fig. 1),
  • power supply with an AC power cable,
  • piece of paper with a link to online documentation,
  • any optional components that you have ordered,
  • Kinect sensor (optional),
  • EMYS master PC controller with power cable (optional).

Gently get EMYS out of the box, it is recommended to hold his base and the back of the middle disk. Holding only the upper/lower disk or the middle disk near the eyes may cause damage to the robot.

Gently unpack EMYS from protective wrapping, do not use any sharp objects which may cause damage to robot’s covers.
Attach EMYS to a fixed base or leave him lying down on a soft surface.



EMYS and FLASH are Open Source and distributed according to the GPL v2.0 © Rev. 0.9.2, 23.11.2017

FLASH Documentation